Adjusting belt length

Post Reply
kag46
Posts: 2
Joined: Sun Aug 16, 2015 7:33 pm

Adjusting belt length

Post by kag46 » Sun Aug 16, 2015 8:23 pm

Hi everybody!

Please advice, printed details have 10% difference on x axis, y is ok, where I can adjust constants for x axis to made modes as it should be?

Thanks!

mava70
Posts: 20
Joined: Sun Nov 01, 2015 8:20 am

Re: Adjusting belt length

Post by mava70 » Tue Nov 17, 2015 9:39 pm

change value in eeprom settings until your printer move 100mm when you command a 100mm x or y move. I did this on a trial by error

Marco

Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests