Error Max Temp Bed
Re: Error Max Temp Bed
I'm back to the original problem again with the error being MAXTEMP BED. Is there anything else I can check regarding this problem? I can't seem to find a short circuit anywhere.
-
- Posts: 1405
- Joined: Fri Feb 06, 2015 1:33 pm
Re: Error Max Temp Bed
What are the resistance of hot bed thermistor and extruder thermistor? Are they both around 90k ohm?
Re: Error Max Temp Bed
The extruder thermistor measures a resistance of 98k ohms and the hot bed thermistor measures 97.3k ohms
Re: Error Max Temp Bed
Dear lalink
maybe you connect the wire of thermistor for extruder to hotbed.Normally,the hotbed temperature is 95 celsius degree.and the extuder temperature is 180 degree for PLA.please check whether the wire of hotbed is connected correctly.
maybe you connect the wire of thermistor for extruder to hotbed.Normally,the hotbed temperature is 95 celsius degree.and the extuder temperature is 180 degree for PLA.please check whether the wire of hotbed is connected correctly.
Re: Error Max Temp Bed
Hello,
I have already tried switching the two thermistors, the machine gives me the same error.
I have already tried switching the two thermistors, the machine gives me the same error.
Re: Error Max Temp Bed
hi,lalink.it's because the wires connectd to the hot bed thermistor are short circuit.please do not get them together.lalink wrote:Hello,
I have already tried switching the two thermistors, the machine gives me the same error.