Open Repetier-Host (Download link: http://www.repetier.com/download-now/), Access "Printer settings":
Set correct baud rate and serial port:
Set amount of extruder as 2, and set correct nozzle diameter:
Then you can control both extruders on Repetier-Host (Note:The extruder can not move unless the temperature is more than 180 degrees):
Slicer setting:
To have a good 3D item,you need to have a good slicer setting, and distribute jobs for 2 extruders:
Click "configuration" to access slicer setting:
For more details of sclicer setting, you can download the attachment to refer:
How to start Geeetech I3 Pro C in Repetier-Host
-
- Posts: 1405
- Joined: Fri Feb 06, 2015 1:33 pm
Who is online
Users browsing this forum: No registered users and 2 guests