How to start Geeetech I3 Pro C in Repetier-Host

Post Reply
zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

How to start Geeetech I3 Pro C in Repetier-Host

Post by zhangxueyou » Tue May 26, 2015 3:02 pm

Open Repetier-Host (Download link: http://www.repetier.com/download-now/), Access "Printer settings":
QQ截图20150526094205.png
QQ截图20150526094205.png (133.12 KiB) Viewed 21199 times
Set correct baud rate and serial port:
choose baud rate and serial port.png
choose baud rate and serial port.png (23.6 KiB) Viewed 21147 times
Set amount of extruder as 2, and set correct nozzle diameter:
QQ截图20150526094443.png
QQ截图20150526094443.png (29.43 KiB) Viewed 21199 times
Then you can control both extruders on Repetier-Host (Note:The extruder can not move unless the temperature is more than 180 degrees):
QQ截图20150526145044.png
QQ截图20150526145044.png (75.72 KiB) Viewed 21199 times
Slicer setting:
To have a good 3D item,you need to have a good slicer setting, and distribute jobs for 2 extruders:
Click "configuration" to access slicer setting:
QQ截图20150526094538.png
QQ截图20150526094538.png (86.4 KiB) Viewed 21199 times
For more details of sclicer setting, you can download the attachment to refer:
slicer settings for I3C.zip
(740.38 KiB) Downloaded 1023 times

patsm00re18
Posts: 12
Joined: Mon Jun 29, 2020 3:42 pm

Re: How to start Geeetech I3 Pro C in Repetier-Host

Post by patsm00re18 » Fri Jul 03, 2020 9:17 am

This one is great info to start my Geeetech I3 Pro C in Repetier-Host. I wanted this guide because I have plans on installing it too.
But I know already how to get free robux online.

Post Reply

Who is online

Users browsing this forum: No registered users and 40 guests