How to use your printer in Mac

nickg
Posts: 6
Joined: Fri Jan 13, 2017 12:01 am

Re: How to use your printer in Mac

Post by nickg » Tue Jan 17, 2017 4:10 pm

Please can i have some help?

thanks

gpau
Posts: 50
Joined: Wed Nov 30, 2016 5:35 pm

Re: How to use your printer in Mac

Post by gpau » Fri Feb 10, 2017 6:20 am

hi,
sometimes it happens to me.
1. try to reinstall the drivers
2. you have to turn off the mac and on again
3. pay attention to not have other programs to stamapante lit 3d create conflict.
However it is strange because the macbook goes smoothly instead on imac occasionally lose my USB port

nickg
Posts: 6
Joined: Fri Jan 13, 2017 12:01 am

Re: How to use your printer in Mac

Post by nickg » Mon Feb 13, 2017 10:52 pm

Hi gpau,

thanks for the answer, I have solved this by replacing the GT2560, as it was faulty.

thanks

N

ZIM372019
Posts: 6
Joined: Thu Jul 04, 2019 2:28 am

Re: How to use your printer in Mac

Post by ZIM372019 » Wed Jul 31, 2019 11:09 pm

tallslenderguy wrote:
Mon Nov 02, 2015 6:32 am
The instructions for Repetier Host for Mac show a "Manual Control" tab, but on my copy there is not a manual control, that tab is labeled "Print Panel." The screen it opens is not the same. I found out how to filezilla uc browser rufus turn on and control the temperature for the extruder and build bed, but there are no arrows for testing the motors manually. I did get the motors to run by pushing the various axis buttons, but could not control off as well as on and my motors did not run well at all (froze while on), so I hit the emergency stop so I would not burn a motor up. It would be nice to have instructions that match the Repetier Host for Mac (it has either changed or I have the wrong one, but I downloaded it from here). I can see where the arrow keys would be nice for testing the motors, but my version of Repetier does not have them.
And if that's not gonna work, you can try 250000 and other values, just make sure the value in printer settings and firmware are the same!

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests