Repetier-Host setting on ABS print

Post Reply
animetown9
Posts: 24
Joined: Thu Feb 26, 2015 4:38 am

Repetier-Host setting on ABS print

Post by animetown9 » Wed Apr 01, 2015 3:33 pm

Hi

I was wondering any have a good setting for Acrylic Geeetech I3 pro B 3D Printer

Repetier-Host, windows 7

Filament 1.75 , nozzle 0.5mm

ABS filament.

thank

zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Re: Repetier-Host setting on ABS print

Post by zhangxueyou » Wed Apr 01, 2015 4:26 pm

Actually, you just need to modify the nozzle diameter and layer height.
slicer settings(1.75-0.5).zip
(569.25 KiB) Downloaded 1870 times

leonardo.galardi@gmail.com
Posts: 11
Joined: Mon Mar 23, 2015 5:54 am

Re: Repetier-Host setting on ABS print

Post by leonardo.galardi@gmail.com » Wed Apr 01, 2015 5:30 pm

I see Extrusion multiplier = 0.6 in Filament Settings, ABS 1.75 mm. Why ? I think it should be 1, right ?

zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Re: Repetier-Host setting on ABS print

Post by zhangxueyou » Wed Apr 01, 2015 5:42 pm

It's hard to say. You can try 0.6 and 1 respectively.

axenias
Posts: 7
Joined: Thu Nov 26, 2015 12:37 am

Re: Repetier-Host setting on ABS print

Post by axenias » Tue Dec 29, 2015 4:23 pm

Hello friends, do you know if these settings are good for nozzle 0.4 too???

Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: Repetier-Host setting on ABS print

Post by Mark » Tue Dec 29, 2015 8:52 pm

I think it will be ok, but I think layer height is too big, I can give you my settings for ABS, using repetier1.6.0 and 1.75-0.4 ,single I3X printer.
config ABS.rar
(1.29 KiB) Downloaded 1612 times

axenias
Posts: 7
Joined: Thu Nov 26, 2015 12:37 am

Re: Repetier-Host setting on ABS print

Post by axenias » Tue Dec 29, 2015 10:40 pm

Ok, well, thank you! I have an i3 pro b printer. I will give a try to your config.

axenias
Posts: 7
Joined: Thu Nov 26, 2015 12:37 am

Re: Repetier-Host setting on ABS print

Post by axenias » Thu Jan 07, 2016 1:48 am

Hello again, i was wondering if there is some ready config for the same bodel but for cura, not repetier! Is anyone know if i3 pro b can play with cura 15.04.3??


Thank you!

Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: Repetier-Host setting on ABS print

Post by Mark » Fri Jan 08, 2016 4:59 pm

I could run the printer with the built-in cura engine in repatier host 1.6.0, so I guess it will be fine.

Post Reply