driver for win 8.1

[jay]

I have windows 8.1 and cannot get the drivers to load on the computer. I have the Repetier software loaded but cannot get it to connect to I3 printer.

[zhangxueyou]

Could you please tell me your board type?

[trahc]

I need the driver for Windows 8.1 as well. the one I loaded from the instructions you have online wont allow me to connect. are there special settings on the com port as well I should set??
its the acrylic i3 with a sadiuo ( sorry cant remember the spelling) board

thanks
Charles Williams'
trahc@yahoo.com

[jay]

I have the mega 2560 + ramps 1.4

[zhangxueyou]

You can refer to this page to intall the driver:
http://www.geeetech.com/wiki/index.php/ ... he_drivers
The driver file is at: arduino-1.0.1-windows\arduino-1.0.1\drivers

[jay]

Finally loaded driver. connected one time. unable to move motors. Now unable to connect again. Shows unable to acess port.

[jay]

Computer shows I have driver software but cannot install drivers.

[zhangxueyou]

Computer shows I have driver software but cannot install drivers.

Computer can not auto install the driver. Did you locate the driver's directory?

[jay]

here is what I've found.

serial install - which opens to

ft2 232r usb uart - which opens to

amd64
i386
CDM 2 06 00 Release info
ftdibus Security catalog
ftdibus Setup Info
ftdiport Security catalog
ftdiport Setup Info
LogoVerificationReport

[zhangxueyou]

Sorry, I don't understand. Please tell me how you intall the driver.