driver for win 8.1
Re: driver for win 8.1
Here are the screen grabs. Hope this helps.
- Attachments
-
- WP_20150412_005.jpg (239.2 KiB) Viewed 11821 times
-
- WP_20150412_004.jpg (170.44 KiB) Viewed 11821 times
-
- WP_20150412_003.jpg (219.27 KiB) Viewed 11821 times
-
- WP_20150412_002.jpg (154.31 KiB) Viewed 11821 times
-
- WP_20150412_001.jpg (228.32 KiB) Viewed 11821 times
-
- Posts: 1405
- Joined: Fri Feb 06, 2015 1:33 pm
Re: driver for win 8.1
Please try to re-load the firmware.
Re: driver for win 8.1
where do I find the firmware?
-
- Posts: 1405
- Joined: Fri Feb 06, 2015 1:33 pm
Re: driver for win 8.1
Please leave your email address, I will send you one.
Re: driver for win 8.1
I have the firmware, but what do I do with it? I downloaded it and unzipped it but no direction .
-
- Posts: 1405
- Joined: Fri Feb 06, 2015 1:33 pm
Re: driver for win 8.1
You can refer to this page:jay wrote:I have the firmware, but what do I do with it? I downloaded it and unzipped it but no direction .
http://www.geeetech.com/forum/viewtopic ... 14&t=16097
Re: driver for win 8.1
I can connect to printer. but no movement in manual and the extruder and bed do not heat.
-
- Posts: 1405
- Joined: Fri Feb 06, 2015 1:33 pm
Re: driver for win 8.1
Did you turn on the printer?
The extruder motor can not move unless the temperature of extruder is more than 175 degrees.
The extruder motor can not move unless the temperature of extruder is more than 175 degrees.
Re: driver for win 8.1
Yes the printer was on. Previously there was info on the lcd screen, this time the screen is now blank. Repetier shows connected. I tried turning on extruder and bed but nothing heats. I turned on the extruder and bed last time but never heated.