Page 1 of 1

Repetier-Host setting on ABS print

Posted: Thu Mar 19, 2015 7:23 pm
by animetown9
Hi

Does anyone here have a good setting for Repetier-Host ABS printing with
Acrylic Geeetech I3 pro and Sanguinololu 1.3a.

Re: Repetier-Host setting on ABS print

Posted: Fri Mar 20, 2015 10:01 am
by zhangxueyou
Please tell me the filament diameter and nozzle diameter.

Re: Repetier-Host setting on ABS print

Posted: Fri Mar 20, 2015 3:22 pm
by animetown9
Hi

Filament 1.75 , nozzle 0.3mm

ABS filament.

Re: Repetier-Host setting on ABS print

Posted: Fri Mar 20, 2015 4:11 pm
by zhangxueyou
slicer settings(1.75-0.3).zip
(715.7 KiB) Downloaded 654 times

Re: Repetier-Host setting on ABS print

Posted: Wed Nov 11, 2015 11:46 am
by johnz
How about setting for 1.75 and 0.4 ABS?? Thanks

Re: Repetier-Host setting on ABS print

Posted: Wed Nov 11, 2015 5:56 pm
by Mark
you can use the settings above too, just need to change the diameter of the nozlle to 0.4mm.
QQ截图20151111175429.jpg
QQ截图20151111175429.jpg (153.12 KiB) Viewed 8542 times
QQ截图20151111175551.jpg
QQ截图20151111175551.jpg (281.52 KiB) Viewed 8542 times
Also you can refer to the link here to use the repetier host:
http://www.repetier.com/#documantation

Re: Repetier-Host setting on ABS print

Posted: Tue Aug 07, 2018 11:19 am
by Derekchong
I followed these setting but the print out is horrible. Any good advise?