Repetier-Host setting on ABS print

Post Reply
animetown9
Posts: 24
Joined: Thu Feb 26, 2015 4:38 am

Repetier-Host setting on ABS print

Post by animetown9 » Thu Mar 19, 2015 7:23 pm

Hi

Does anyone here have a good setting for Repetier-Host ABS printing with
Acrylic Geeetech I3 pro and Sanguinololu 1.3a.

zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Re: Repetier-Host setting on ABS print

Post by zhangxueyou » Fri Mar 20, 2015 10:01 am

Please tell me the filament diameter and nozzle diameter.

animetown9
Posts: 24
Joined: Thu Feb 26, 2015 4:38 am

Re: Repetier-Host setting on ABS print

Post by animetown9 » Fri Mar 20, 2015 3:22 pm

Hi

Filament 1.75 , nozzle 0.3mm

ABS filament.

zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Re: Repetier-Host setting on ABS print

Post by zhangxueyou » Fri Mar 20, 2015 4:11 pm

slicer settings(1.75-0.3).zip
(715.7 KiB) Downloaded 462 times

johnz
Posts: 23
Joined: Mon May 18, 2015 12:37 pm

Re: Repetier-Host setting on ABS print

Post by johnz » Wed Nov 11, 2015 11:46 am

How about setting for 1.75 and 0.4 ABS?? Thanks

Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: Repetier-Host setting on ABS print

Post by Mark » Wed Nov 11, 2015 5:56 pm

you can use the settings above too, just need to change the diameter of the nozlle to 0.4mm.
QQ截图20151111175429.jpg
QQ截图20151111175429.jpg (153.12 KiB) Viewed 5834 times
QQ截图20151111175551.jpg
QQ截图20151111175551.jpg (281.52 KiB) Viewed 5834 times
Also you can refer to the link here to use the repetier host:
http://www.repetier.com/#documantation

Derekchong
Posts: 10
Joined: Sun Jul 08, 2018 1:03 am

Re: Repetier-Host setting on ABS print

Post by Derekchong » Tue Aug 07, 2018 11:19 am

I followed these setting but the print out is horrible. Any good advise?
Attachments
20180806_220632.jpg
Abs hollow cube
20180806_220632.jpg (239.55 KiB) Viewed 3113 times

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest