Extruder motor don't work
Posted: Sun May 10, 2020 4:30 am
Hi, I bought a Geeetech I3 pro B and I mounted it but when I try to use I noticed that the motor of the extruder didn't work, after I have attach it at X motor connector and the motor started. I refreshed th firmware on the board but the problem persists. I have changed in pins.h the configuration of pins and I reversed the pin of X motor with the pin of Extruder motor and I tried to run the extruder motor moving X axis and it started but the opposite port has stopped working moving Extruder, so I could see that the port of Extruder motor works.
So the motor works, the cable is good, the port of Etruder motor works, but when I mount all together in the right way the Extruder motor don't start. WHY? There is a problem with firmware I suppose but I used the firmware that I have find on this site
So the motor works, the cable is good, the port of Etruder motor works, but when I mount all together in the right way the Extruder motor don't start. WHY? There is a problem with firmware I suppose but I used the firmware that I have find on this site