Page 1 of 1

how to connect USBtinyISP Programmer to GT2560 V4 board

Posted: Sun Jan 12, 2020 6:00 pm
by jrrrst
I have to flash my board with a new bootloader. The new borad GT2560 V4 doesnt have the 6 pin connector anymore.
I can not find anywhere information how to connect the programmer with the board.
Who can help? best with picture

Re: how to connect USBtinyISP Programmer to GT2560 V4 board

Posted: Tue Jan 14, 2020 9:40 pm
by jrrrst
Thank you very much. Hope this also can help others

Re: how to connect USBtinyISP Programmer to GT2560 V4 board

Posted: Sat Mar 14, 2020 3:57 am
by FranatiX
Take a look at the backside of the mainboard. I can't believe that it's possible to flash a bootloader using the 9pin header. To me it looks like it is to connect x,y,z max endstops.

Re: how to connect USBtinyISP Programmer to GT2560 V4 board

Posted: Sun Mar 15, 2020 12:59 pm
by Paul Matthews
Hi so witch 6 pins do we use to flash a bootloader in your photo please

Re: how to connect USBtinyISP Programmer to GT2560 V4 board

Posted: Sun Mar 15, 2020 6:50 pm
by jrrrst
Anybody know where on the GT2560 V4 board to connect the USPTiny programer?

Re: how to connect USBtinyISP Programmer to GT2560 V4 board

Posted: Thu Apr 16, 2020 2:37 pm
by Lakyn
Anyone?

Re: how to connect USBtinyISP Programmer to GT2560 V4 board

Posted: Sun Apr 26, 2020 7:34 am
by Lakyn
Managed to trace it.
GT2560_V4_pins.jpg
GT2560_V4_pins.jpg (337.79 KiB) Viewed 5685 times