Regarding GT2560 4.0 unable to flash firmware and unable to print online
Posted: Tue Dec 10, 2019 10:49 am
Hi,guys
the way about GT2560 4.0 unable to flash firmware and unable to print online
If your computer cannot automatically generate a serial port,
You need to install the driver manually;
For specific operations, you can refer to: https://www.geeetech.com/forum/viewtopi ... RlcFtWdCG4
*The incorrect baud rate of the serial port may also cause the failure to connect. The correct baud rate is 250000.
PS:The printer needs to be turned on when upgrading
When you plug in the USB cable, the printer will not reset, which means there is no reset function;
The firmware needs to be reset (click Upgrade and from the local while pressing the reset button on the screen);
Or press and hold the reset button on the screen, click Upgrade and release the reset button.
Here are two ways to flash the hex firmware:
1.Update with cura
you can refer to this: Need to hold the printer's reset button while updating the firmware to update!!!
For specific operations, you can refer to:viewtopic.php?f=20&t=69704
2.Update with Firmware Toolkit
you can refer to this: Need to hold the printer's reset button while updating the firmware to update!!!
For specific operations, you can refer to:viewtopic.php?f=20&t=69684
the way about GT2560 4.0 unable to flash firmware and unable to print online
If your computer cannot automatically generate a serial port,
You need to install the driver manually;
For specific operations, you can refer to: https://www.geeetech.com/forum/viewtopi ... RlcFtWdCG4
*The incorrect baud rate of the serial port may also cause the failure to connect. The correct baud rate is 250000.
PS:The printer needs to be turned on when upgrading
When you plug in the USB cable, the printer will not reset, which means there is no reset function;
The firmware needs to be reset (click Upgrade and from the local while pressing the reset button on the screen);
Or press and hold the reset button on the screen, click Upgrade and release the reset button.
Here are two ways to flash the hex firmware:
1.Update with cura
you can refer to this: Need to hold the printer's reset button while updating the firmware to update!!!
For specific operations, you can refer to:viewtopic.php?f=20&t=69704
2.Update with Firmware Toolkit
you can refer to this: Need to hold the printer's reset button while updating the firmware to update!!!
For specific operations, you can refer to:viewtopic.php?f=20&t=69684