Hi All,
I'm trying to add a BL Touch to my Aluminium Pro A the one with the separate control box and leadscrews.
I have downloaded the firmware for my printer but have a problem with trying to identify the correct lines to alter in the pins.h
section as instructed in the Geeetech BL touch manual.Any help would be great or a copy of the firmware already setup for the
BL touch would be even better.
Cheers
Barry
Bl Touch firmware
Re: Bl Touch firmware
I am afraid that all aluminum models are not suitable for installing 3D Touch.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Bl Touch firmware
Hi William,
It appears a BL touch can be used I found this on the forum http://www.geeetech.com/forum/viewtopic ... 499#p91203
So I will try the method he describes. The only thing that I would have preferred is a method of connecting to the terminals on the sub board on the printer and not having to go to the main board in the control box.
Cheers
Barry
It appears a BL touch can be used I found this on the forum http://www.geeetech.com/forum/viewtopic ... 499#p91203
So I will try the method he describes. The only thing that I would have preferred is a method of connecting to the terminals on the sub board on the printer and not having to go to the main board in the control box.
Cheers
Barry
Re: Bl Touch firmware
,OK,Worth a try.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!