Page 1 of 1
A30M Extruding different lengths between sides for same feed length
Posted: Mon Sep 07, 2020 8:29 pm
by Deadeye
Hi, I have an A30M and I’m trying to calibrate the Filament steps. I have it set to 140 and when I try to extrude 100mm, on E0 it extrudes 90mm and on E1 it extruders 100mm. Any ideas why there is a difference?
Re: A30M Extruding different lengths between sides for same feed length
Posted: Tue Sep 08, 2020 9:31 am
by William
Hello, the tightness of your extruder gear may be the cause of this phenomenon, you can calibrate the extruder, you can refer to the link below for calibration.
https://www.youtube.com/watch?v=xzQjtWhg9VE