GEEETECH A20M SD Card print works fine, USB does not
Posted: Wed Jan 15, 2020 10:24 am
Hi all,
I got my A20M last week, and I've spent every day since trying to get the thing to print correctly. I use Repetier connected via USB (same setup I used on my old Anet A8), but the filament won't stick correctly, it under extrudes, the extruder motor clicks against the filament, etc. I've tried cleaning the nozzle, replacing the filament, tightening the extruder, nothing has worked. I just tried printing from the SD card that came with the printer, and...
It worked perfectly.
There was some stringing, but I'll address that issue later. For now, I'm trying to figure out why I can't print over USB but SD print works fine. Does anyone have any ideas?
Thank you,
Oddity
I got my A20M last week, and I've spent every day since trying to get the thing to print correctly. I use Repetier connected via USB (same setup I used on my old Anet A8), but the filament won't stick correctly, it under extrudes, the extruder motor clicks against the filament, etc. I've tried cleaning the nozzle, replacing the filament, tightening the extruder, nothing has worked. I just tried printing from the SD card that came with the printer, and...
It worked perfectly.
There was some stringing, but I'll address that issue later. For now, I'm trying to figure out why I can't print over USB but SD print works fine. Does anyone have any ideas?
Thank you,
Oddity