GS2 Extruder stop working but the day before it was

Post Reply
User avatar
William
Site Admin
Posts: 5130
Joined: Tue Jun 07, 2016 9:38 am

Re: GS2 Extruder stop working but the day before it was

Post by William » Wed Nov 27, 2019 11:42 am

Hi, If you mean that the motor of the extruder is not working properly,
You can try to exchange with the motor wire and extruder motor wire that other shafts work normally.
Determine if this is happening due to broken motor wires;
Then you can try to exchange the drive plate of the other shaft with the drive plate of the extruder to determine if the voltage of the drive plate is too low to cause this.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests