How to fix the issue of extruder(D200)

Post Reply
User avatar
Admin
Posts: 267
Joined: Wed Nov 30, 2011 9:49 am

How to fix the issue of extruder(D200)

Post by Admin » Mon Nov 27, 2017 3:07 pm

Recently, I received a lot of questions about the D200 extruder.
For this reason, I specifically provide some solutions about how to fix this issue.
If the nozzle clogged what should we do?
1.You should heat the nozzle temperature up to 220C and then adjust the extruder according to the actual situation.
NOZZLE.png
NOZZLE.png (631.96 KiB) Viewed 3335 times
If the nozzle heat up to 220 and it still clogged, what should we do?
1.We can use the attached Ejector pin, poke down from the feed inlet until all residual filament discharge.
ZHEN.jpg
ZHEN.jpg (141.23 KiB) Viewed 3335 times
If the nozzle temperature display in LCD with -17C or others wrong temperature, what should we do?
1.You should check out whether the nozzle and the extruder contact point are closely connected together
(If there is foreign matter, please wipe with paper towel.)
contact point.png
contact point.png (237.82 KiB) Viewed 3335 times
If the extruder does not move properly and jitter,what should we do?
1.You can open the cable to see if the pins are crooked and not touching each other well.If yes, you can carefully adjust the crooked pin via tweezers until it can be fully inserted into the jack.
INSERT.png
INSERT.png (157.74 KiB) Viewed 3335 times
If the nozzle is not clogged, but it makes noise with"clicking, clicking"and you need to give it a downward force, what should we do?
1.You should test the voltage of extruder driver(TMC2100) via multimeter, normal is about 1.2V.If it is not normal, you should adjust it refer to
viewtopic.php?f=19&t=17097
D200-V.png
D200-V.png (595.21 KiB) Viewed 3335 times
TMC2100.png
TMC2100.png (478.79 KiB) Viewed 3335 times
Due to various reasons, can not list more questions, if your D200 extruder meet other issues, please list the issue and details about it below.

Post Reply

Who is online

Users browsing this forum: No registered users and 6 guests