Printing too high
Printing too high
So ive completely calibrated my aluminum prusa i3 (nozzle at as it can go while still allowing the movement of a piece of paper) but my prints still don't come out looking like anything close to what they should look like. The filament comes out into a curly mess. Now I think ive found the problem, when I watch my 3d printer print the nozzle isn't very close to the glass I think its the settings on repitier host but I have no idea where this setting would be or what it would be called.
Re: Printing too high
I think you should modify the Z steps/mm to 400.
The best way is to upload the firmware again.
viewtopic.php?f=10&t=17046
You need to choose the firmware named "Plusa_I3_A_sanguinololu(for the upgraded kit using lead screw)" of Aluminum I3.
The best way is to upload the firmware again.
viewtopic.php?f=10&t=17046
You need to choose the firmware named "Plusa_I3_A_sanguinololu(for the upgraded kit using lead screw)" of Aluminum I3.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Printing too high
Oh god not again one of my earlier problems was the stepper motors for the z was reversed (+ would go down - up) and I tryed for a good couple of weeks and couldn't get it to upload (error message i cant remeber) so instead I just snipped the wires and reversed them, is there any other way?
Re: Printing too high
You can modify the direction in configuration.h file of MARLIN firmware.
There is a post you can refer to :
viewtopic.php?f=17&t=17037
There is a post you can refer to :
viewtopic.php?f=17&t=17037
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Printing too high
i reinstalled the firmware and it still prints way too high, its still perfectly calibrated
Re: Printing too high
i have a picture of my latest test print is there a way i can post it here
Re: Printing too high
You should upload the firmware I attached.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!