Hello,
I assembled the G2S Pro kit, and on my first attempts to print....PLA oozing everywhere.
I disassembled the hotend to clean it, and discovered there is no PTFE tube inside the 'throat'. Nor is there one in the second hotend.
Since this is the 1.75mm hotend, it should have a PFTE insert?
-Teo
Missing PFTE tubes?
Missing PFTE tubes?
- Attachments
-
- IMG_0249.JPG (82.46 KiB) Viewed 7463 times
Re: Missing PFTE tubes?
There should be a PTFE tube in it, I think you can contact the seller for it.
Re: Missing PFTE tubes?
Contact seller.....Yeah, I've been trying. I bought directly from Geeetech, and have yet to get a response from 'sales' or 'tech support'.
Re: Missing PFTE tubes?
You can send a e-mail to sales@geeetech.com.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Missing PFTE tubes?
had the same Problem on My G2S Pro kit.
The PTFE tube from the Extruder Motors to the hotend fit in the threaded rod.
I cut a Piece and put it into the threaded rod.
Tip: cute the ptfe tube 1 mm longer than the threaded rod.
Why? look here.
https://www.youtube.com/watch?v=OoShQSrrYdA
The PTFE tube from the Extruder Motors to the hotend fit in the threaded rod.
I cut a Piece and put it into the threaded rod.
Tip: cute the ptfe tube 1 mm longer than the threaded rod.
Why? look here.
https://www.youtube.com/watch?v=OoShQSrrYdA