Strange behavior by printing (ozzing or jams?)
Hi All,
i am an new bee here and try to optimize my prusa i3x.
I adjusted retraction length settings from 2 to 10 and reduced speed to 50 but it has no positive impact on quality.
Do you have some ideas? How can I adjust the settings of slic3r? What parameters / What is is good increment step (e.g. +5 +10)
Here is a picture of results
Many thanks in advance!
Strange behavior by printing (ozzing or jams?)
Strange behavior by printing (ozzing or jams?)
- Attachments
-
- pic1.JPG (26.32 KiB) Viewed 5121 times
Re: Strange behavior by printing (ozzing or jams?)
retraction length too big, usually 3-4mm is enough, and speed 40-50 is fine. I have a config settings for you here, see if it helps:
Re: Strange behavior by printing (ozzing or jams?)
Many thanks Mark.
I will try your settings
I will try your settings