Geeetech

Hello,

Just bought the Acrylic I3 Pro. Finished assembly yesterday. X, Y, Z motors all working correctly. Extruder motor is not turning. Plugged extruder into X plug and motor works. Tried X motor in the extruder plug and does not turn. Uploaded Marlin firmware and has not fixed the issue.

Need help please.

Todd

how about reburn the fimware.the upgraded firmware has been sent to your mailbox.

Shortly after I posted I found the Pro B version of the firmware, fixed up the extruder motor issue. Then I found that repetier was set on 3mm filament instead of 1.75.

After those changes, boom - I got a print.

If this board is not working, then you should new pro B new version of firmware to fix this extruder issue. The assignment writing service uk offers some unique and helpful tips regarding to writing skills. You can check for further information.