Geeetech • How to improve the surface condition of the print?

Page 1 of 1

How to improve the surface condition of the print?

Posted: Tue Jul 07, 2015 7:17 pm

by Laluuh

Everything is in the title,
The first print was good, but since it's not terrible, printing are twisted. etc ..
How to improve all this? thank you

Good print (first print) :
http://image.noelshack.com/fichiers/201 ... -print.jpg

Bad print (now) :
http://image.noelshack.com/fichiers/201 ... rint-1.jpg
http://image.noelshack.com/fichiers/201 ... rint-2.jpg
http://image.noelshack.com/fichiers/201 ... rint-3.jpg
http://image.noelshack.com/fichiers/201 ... rint-4.jpg

Re: How to improve the surface condition of the print?

Posted: Wed Jul 08, 2015 11:41 am

by Sherry

hi,please do the following steps.
1.Tight coupling shown in the picture.
2.the hot bed is out of level,please do the auto leveling .

Re: How to improve the surface condition of the print?

Posted: Wed Jul 08, 2015 11:44 am

by Sherry

coupling