Page 2 of 3
Re: FAQ
Posted: Sun Aug 30, 2015 7:22 am
by fotomickey
I'll be interest to see a post video show how to disassemble Hot-head after usage too. My experience its impossible to dissemble after used (glued in). It is very frustrated process for me Thanks
Re: FAQ
Posted: Tue Sep 15, 2015 11:07 pm
by Sandcrab3
No one has an answer for this. If not a video, a step by step procedure. I know that Geetech must know how this is done, even if the farm out the process for their assembled parts.
Re: FAQ
Posted: Thu Sep 17, 2015 6:08 pm
by Mark
Re: FAQ
Posted: Thu Sep 17, 2015 11:38 pm
by fotomickey
As mentioned on the post, I want to see how the hotends disassemble after being used, it seem there are design faluse the hotends cannot deassemble after used. is It became 1 time use hotend. Please show a new video on use hotends to enlighten me if assumed wrong
Thanks
Re: FAQ
Posted: Sat Sep 19, 2015 4:09 pm
by Mark
you can refer to the picture bellow:
Re: FAQ
Posted: Sat Sep 19, 2015 11:33 pm
by fotomickey
Hi Mark, what about Delta Hotends, please show new video
Re: FAQ
Posted: Mon Sep 21, 2015 5:45 pm
by Mark
They are the same ones.
Re: FAQ
Posted: Tue Sep 22, 2015 1:45 am
by fotomickey
Hi Mark
Please verify the design , Delta used J head which has heat resistance barrel, that is nothing in common with above picture.
Re: FAQ
Posted: Tue Sep 22, 2015 4:36 pm
by Mark
You mean the PEEK one, right? I suggest do not disassemble the PEEK Jhead, it's hard to make it work agian..
Re: FAQ
Posted: Wed Sep 23, 2015 12:06 am
by fotomickey
Hi Mark
Then you confirm J head is dead once clogged. What sort of solutions/ options left for G2 delta. ? Please advise