Page 1 of 1
Videos of MK8 Extruder assembly
Posted: Fri May 29, 2015 10:35 am
by zhangxueyou
In this video, you will see how to tear the
mk8 extruder down, and how to replace new extruder kits.
https://www.youtube.com/watch?v=aPvVUZQnOMM
How to replace extruder thermistor:
https://www.youtube.com/watch?v=FR0n2FHrjmc
How to replace nozzle:
https://www.youtube.com/watch?v=t2tUxrZDi8o
How to level dual extruder:
https://www.youtube.com/watch?v=XGpcueI ... e=youtu.be
Re: Videos of MK8 Extruder assembly
Posted: Wed Nov 25, 2015 5:29 am
by mava70
hello the heater and the thermistor move inside the hole out and in, can be fixed someway?
Re: Videos of MK8 Extruder assembly
Posted: Wed Nov 25, 2015 2:44 pm
by Mark
there's a setscrew for the heating cartridge, did you see that? and you can use a cable tie to tie them up.
Re: Videos of MK8 Extruder assembly
Posted: Wed Nov 25, 2015 3:15 pm
by mava70
Hello there is a small hex screw next to the hole in the back but I tryed to turn clockwise the screw go inside the hole a lot but don't fix. Should I turn a lot more?
Re: Videos of MK8 Extruder assembly
Posted: Wed Nov 25, 2015 3:56 pm
by Mark
I remember the setscrew is side of the heating block not in the back, maybe you need to remove the sponge thing to check it, and you can screw it a little tight.
Re: Videos of MK8 Extruder assembly
Posted: Sun Jun 16, 2019 9:44 pm
by calabrovarijo
is side of the heating block not in the back, maybe you need to remove the sponge thing to check it, and you can screw it a little tight.
Re: Videos of MK8 Extruder assembly
Posted: Mon Jul 04, 2022 2:51 pm
by randyhavens
You can try removing the sponge thing to check it, and screw it a little tight.
gmail sign up