Post
by hardsmar » Wed Apr 29, 2020 8:35 pm
@Mortega: i'm having similar problems did you make any progress? are you able to find the diagram of the v4 board?
I can't believe this 'open source' thing: no source code for the firmware, yet disguised by 'open source', no documenation, no official support from vendor.
no official support from the vendor (their stuffs do help in the forum - while customer thanks voluntary assistance from the community, they deserve official support from the vendor, not staffs acting as 'community members' to provide voluntary help as they see fit, or simply let customer simply continue to frustrate.
I'm considering a refund if i can't get anywhere (after 3 weeks of frustration) and will demand a refund, then either buy a true open source printer, or one backed by the vendor (documenation & support), or by a true community (not a few employees in a forum just to replace support)