Geeetech

My control board for Rostock 301, a GTM32 pro control board has burnt. I've tried to buy a new one but i didn't find it. Although I've found the previous version of the board, the GTM32 board. Is it compatible this printer with this board if I use the old version of the firmware or even the newest firmware and I change the connections and pins of the wires?

Hi,
I'd better go with a new one (GTM32 pro). I had a Geeetech A10 Pro with a GT2560 V4 control board. Then I used a GTM32 PRO VD Control Board for my A30. Never made a custom build.



Dremel Digilab in my classroom: case study by essay writer