1 post • Page 1 of 1
Just got a auto level sensor. Excited to see how it works. Running 24v on the GT2560 board. I understand that it needs resistors to work properly. I have this sensor I got off of amazon. Uxcell LJ12A3-4-Z/AY PNP NC Distance Inductive Sensor Proximity Switch, 4 mm. Says 10-30v. Completely clueless on how it gets wired and google shows so many different ways. Not sure what to trust. Help???
Who is online
Users browsing this forum: No registered users and 2 guests