Homing

Post Reply
Dhiva
Posts: 0
Joined: Wed Jan 17, 2018 1:32 pm

Homing

Post by Dhiva » Thu Feb 01, 2018 2:39 pm

Hi
I am fabricating a 3d printer. I bought a P13A pro ( GT2560 ) controller from GEEETECH and using Printrun as a host software. I did nothing in the firmware of the controller. After connecting the stepper motors with the axis i want to move the axis for home position. While i press home there is no continuous movement. It moved a little and stopped. But in the other direction the movement is continuous. As far as I know the movement should be continuous until it reaches the limit switch . What is the error? How to rectify it?

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Homing

Post by William » Fri Feb 02, 2018 6:06 pm

I think you should check the wiring of endstop and itself(Send M119 for test)
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply