Z axis don't go home and down

Post Reply
bornancini
Posts: 1
Joined: Wed Sep 02, 2020 2:09 pm

Z axis don't go home and down

Post by bornancini » Wed Sep 02, 2020 2:19 pm

On I3B Z axis don'go down.

Manual move to home make printer ready and the job is done well.

Inverting logic of dip switch of Z home make the Z go home, press the switch but don't stop.

Giacomo

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Z axis don't go home and down

Post by William » Wed Sep 02, 2020 3:56 pm

Hi,
1. There may be a problem with the z-axis drive. You can exchange drives with other axes to see if it is normal.
2. Whether the firmware is normal, please check for updates.
3. If you have installed 3d touch, remove it to see if it works normally.
4. You can also refer to the following solutions. :D
http://geeetech.com/forum/viewtopic.php?f=82&t=60931
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply