Hi, i've bought 2 geetech mini168 and the usb converter. The Converter is this one:
and the Mini is this one:
There is a connection schematic in the website :
I've tried the 2 connection types but i couldn't programm my mini168. It allways give the error that i show in the "error_mini.jpg" file (in the attachments). My latest connection you can see on the files mini1,jpg, mini2.jpg and mini3.jpg. I've chose pro mini 5v,16MHZ w/ ATMega168, but it allways give's the same error. I've tried to push the reset button, and nothing, can anyone help me?
Problem programming mini 168 with usb
Problem programming mini 168 with usb
- Attachments
-
- mini2.JPG (91.33 KiB) Viewed 14915 times
-
- mini1.JPG (111.26 KiB) Viewed 14915 times
-
- error mini168
- error_mini.jpg (97.53 KiB) Viewed 16747 times
Re: Problem programming mini 168 with usb
Hi friend,
Please keep pushing the reset button on Pro Mini, then upload your sketch.As soon as the LED on the USB converter flash, release the reset button.
Regards,
Jack
Please keep pushing the reset button on Pro Mini, then upload your sketch.As soon as the LED on the USB converter flash, release the reset button.
Regards,
Jack
Re: Problem programming mini 168 with usb
Thanks for the reply, but i've made that and doesn't work. Do ineed a seperate power supply to program it?
Re: Problem programming mini 168 with usb
Hi, i've tried to programm my second mini and works fine. I think the fisrt one is damaged.
Re: Problem programming mini 168 with usb
Hi, I bought four geetech Pro Mini Atmega 168 5V/16MHz and transmitter Nano USB converter module. Did not get to program, shows the same error. The driver is fresh, checked all the same port, 19200. Tell me what could be the reason? What am I doing wrong? This is my first steps as Arduino, please help.
Re: Problem programming mini 168 with usb
jack wrote:Hi friend,
Please keep pushing the reset button on Pro Mini, then upload your sketch.As soon as the LED on the USB converter flash, release the reset button.
Regards,
Jack
Re: Problem programming mini 168 with usb
Hi, no problem! geetech Pro Mini Atmega 168 5V/16MHz was intact. The reason was Nano USB converter. Poorly soldered a 1 contact (TXD) FT232RL, soldered and everything just worked! Thanks for the advice!
Re: Problem programming mini 168 with usb
Hi Dimaris;
It's good to know that you have solved the problem. Good luck with your project buiding.
regards,
Jack
It's good to know that you have solved the problem. Good luck with your project buiding.
regards,
Jack