Geeetech i3 ProB Y axis always triggered

[Scuall]

Y axis moving toward to me a 10mm and stop, when manually pressing Home.
M119 command gives, that Y-min is triggered, always, when i manually pressing switch or no.
When removing switch, or manually shorten wires, M119 gives still, that Ymin is triggered.
It like häving somekind feminazi in my home, whos always triggred.
Otherwise, all Works good, no mirror and printing fine.

[Cup]

Maybe you can refer to this to modify the pin assignment of Y_min and Y_max to take a look:
viewtopic.php?f=20&t=18020