G2/G2S Head switch
Posted: Fri Apr 29, 2016 9:20 am
I've just finished (mostly) assembling my kit. I've been having issues with the y axis not seeming to calibrate correctly but I think I need to go back in the firmware and check out the settings there (X and Z will move up on homing but Y will move down... I'm assuming its the firmware Y reverse that needs to be changed). I did find out the "not mostly" part I overlook on the assembly. That is the wiring for the switch on the print head. Now I found I was missing the harness for it....no big deal I can make one of those up... but where does it plug into? The board Layout doesn't say. I'm assuming it will be the Y-Min connection, but wanted to ask and see where it's actually suppose to go once I get it built up. Then I'll be moving on to finalizing the calibration to hopefully get my first print this weekend.