I have assembled and successfully tested the motion. However, I am reticent to attempt to print as I see a potential problem. Hopefully, someone here can allay my fears or provide a fix that won't cost me waiting for something on a boat.
As I look at the front of my printer, the bracket holding the extruders is lower than the extruders. See pic.
There are no examples I can find showing this metal bracket and how it is supposed to look. In my motion tests, this bracket touches the hotplate (glass was not attached, thank goodness) and I could see it stressing the hotplate with the extruders 5+mm from the hotplate.
Can someone assist me in getting my printer working so it's not self-destructive?
With appreciation,
Robert