Page 1 of 1
G2S Bed won't heat past 80c
Posted: Mon Oct 19, 2015 9:04 pm
by bridge2nowhere
I set the bed temperature to 100 for ABS, and it won't go past 80. Since the bed feels hot, and registers a temperature, I don't think I've set anything up wrong.
I've tried setting the temperature in both repetier host, and from the lcd on the printer. The extruders both heat up fine, so there isn't a problem there.
Re: G2S Bed won't heat past 80c
Posted: Tue Oct 20, 2015 3:31 pm
by Sherry
bridge2nowhere wrote:I set the bed temperature to 100 for ABS, and it won't go past 80. Since the bed feels hot, and registers a temperature, I don't think I've set anything up wrong.
I've tried setting the temperature in both repetier host, and from the lcd on the printer. The extruders both heat up fine, so there isn't a problem there.
some of hot bed are improperly wire.please refer to the link.
http://reprap.org/wiki/Delta_Rostock_mi ... tbed_Coils
In addition,it do takes about 1 hour to raise the hot bed to 100° . the more temperature of hot bed you increase ,the faster the temperature dissipate.so you will find that it will increase to 70°-80° in a fast speed,but it take almost an hour to over 100° .