solution for G2S extruder2 drives axial motors

Post Reply
Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

solution for G2S extruder2 drives axial motors

Post by Mark » Sun Oct 11, 2015 1:38 pm

Hi guys, if you run into the problem that the G2S extruder2 drives axial motors when printing, you can try to solve it by reinstall the latest firmware, and change some setting here. You can have a try but ready to press the emergency button if necessary!

Download the latest firmware here:
http://www.geeetech.com/forum/viewtopic ... 10&t=17046

For the distance of the two extruders is 20mm, you should set the Y offset in the printer settings and the slice software as follows.
Do note that if your spider is the metal one, the distance is 26mm!

1. printer settings:
01.jpg
01.jpg (133.38 KiB) Viewed 30807 times
2. settings in slic3r:
02.jpg
02.jpg (112.27 KiB) Viewed 30807 times
03.jpg
03.jpg (96.81 KiB) Viewed 30807 times
3. Add "M84 S0" to the gcode here:
QQ截图20151020084951.jpg
QQ截图20151020084951.jpg (169.89 KiB) Viewed 30693 times
If you want to add the G29 to test the auto-leveling, add it here:
04.jpg
04.jpg (106.98 KiB) Viewed 30807 times
If you have some problems duing the test please feed back it here, we'll try to fix it, tks!

xyvew
Posts: 1
Joined: Fri Dec 31, 2021 1:17 pm

Re: solution for G2S extruder2 drives axial motors

Post by xyvew » Fri Dec 31, 2021 1:18 pm

Gree tech is the advance website of making the solutions with the life lines of the achievements. These are frequently used products that can make the pattern of the australianwritings with the solution to the axial motors in the same theme of work with all of these.

Post Reply