G2S Pro Motor timeout / Head dropping

[woundedknee]

Hi,

Is there any way to prevent the motors from timing out and the print head dropping on the G2S Pro printer? It gets annoying while trying to calibrate and print when the head suddenly drops to the bed.

Thanks for your help!

Dave

[Mark]

uh...you can manually move the Z axis now and then to keep it busy I think.
And maybe set it here:

12.jpg (196.31 KiB) Viewed 7228 times

11.jpg (287 KiB) Viewed 7228 times

[woundedknee]

Mark,

Thank you very much! Very useful.

Dave

[Mark]

I just find out another way, you can check it here:
http://www.geeetech.com/forum/viewtopic ... 519#p28519