Extruder only reacts how to fix
Extruder only reacts how to fix
My extruder will only retract but won't extrude how do I fix this as to I can't find any solutions
Re: Extruder only reacts how to fix
Is it clogged? you can check it here:
http://www.geeetech.com/forum/viewtopic ... 13&t=17097
http://www.geeetech.com/forum/viewtopic ... 13&t=17097
Re: Extruder only reacts how to fix
It hasn't bin used yet just trying to load it but it only retracts dousnt extrude
Re: Extruder only reacts how to fix
you mean the motor direction is inversed, right?
then you need to change the motor direction: http://www.geeetech.com/forum/viewtopic ... 13&t=17037
then you need to change the motor direction: http://www.geeetech.com/forum/viewtopic ... 13&t=17037