Z-Axis Backlash

[ChrisH90]

Dear all, I have the issue that I have a enourmous Backlash in Z Axis. I can move the Z-Glider for about 2mm up and down without moving the Stepper. Any ideas how to tighten the Z-Axis?

[Brandon511]

Thanks For The Great ConTent Sir. I Will also shaer with my Friend & ones again Thanks a lot.
[https://customersurveyz.onl/www-tellgnc-com/]

[Najeraa]

Dear all, I have the issue that I have a enourmous Backlash in Z Axis. I can move the Z-Glider for about 2mm up and down without moving the Stepper. Any ideas how to tighten the Z-Axis?
Tellpizzahut

the Z-Axis position on the control. If the difference is more than 0.0002" (0.005 mm), the backlash is too large.

[Mathis17425]

Thanks to this article I can learn more. Expand my knowledge crediblebhand abilities. Actually the article is very real.