Nozzle Turning Off During Print
Posted: Sun Jan 12, 2020 7:16 am
Hey,
I believe the issue I'm having is firmware related, but I decided to open a new thread.
During prints, everything will be going great until near the end (usually the last 5-30 min depending on layer, and size of print). Randomly, the printer will turn the nozzle off, but continue to try and print until it reaches a "Temp too low", and it will pause. When trying to resume the print, it will acknowledge the preheat, but will not heat up, and cause a "Heater Fail", which in turn forces me to reset the printer, cancelling the print. I've checked extruder settings, printer settings, and the gcode of all the slices, and have come up with nothing. With this in mind, this only seems to happen when I am trying to print with multiple extruders (2 or 3). If I print with a single extruder, I do not have any issues. That being said, I have to use EX0 to print in one color, and not EX1 or EX2, otherwise the same thing happens. This is what leads me to believe that it is a firmware issue.
Other issues I have been having include printer resets when trying to click on the "color mixer" option of the LCD screen. The current firmware I am using is the (Firmware For A10T(GT2560 V4.0 support 3d touch)). The other firmware that does not have BLtouch support has never given me any issues.
Curious if anyone else has had issues and/or have heard of these issues. I Have not heard back from Geeetech yet (2 weeks now), so I'm hoping there is some sort of solution out there, other than going back to the original firmware without the BLtouch.
Thanks
I believe the issue I'm having is firmware related, but I decided to open a new thread.
During prints, everything will be going great until near the end (usually the last 5-30 min depending on layer, and size of print). Randomly, the printer will turn the nozzle off, but continue to try and print until it reaches a "Temp too low", and it will pause. When trying to resume the print, it will acknowledge the preheat, but will not heat up, and cause a "Heater Fail", which in turn forces me to reset the printer, cancelling the print. I've checked extruder settings, printer settings, and the gcode of all the slices, and have come up with nothing. With this in mind, this only seems to happen when I am trying to print with multiple extruders (2 or 3). If I print with a single extruder, I do not have any issues. That being said, I have to use EX0 to print in one color, and not EX1 or EX2, otherwise the same thing happens. This is what leads me to believe that it is a firmware issue.
Other issues I have been having include printer resets when trying to click on the "color mixer" option of the LCD screen. The current firmware I am using is the (Firmware For A10T(GT2560 V4.0 support 3d touch)). The other firmware that does not have BLtouch support has never given me any issues.
Curious if anyone else has had issues and/or have heard of these issues. I Have not heard back from Geeetech yet (2 weeks now), so I'm hoping there is some sort of solution out there, other than going back to the original firmware without the BLtouch.
Thanks