Firmware with working 3D touch?

Post Reply
TehZuCC
Posts: 3
Joined: Tue Jan 21, 2020 6:07 am

Firmware with working 3D touch?

Post by TehZuCC » Tue Jan 21, 2020 6:11 am

Has anyone gotten 3d touch to work correctly? Just upgraded firmware to V1.01.01 and the auto leveling screen still does not allow me to select 3D touch, still stuck on "CAS". Also no buttons for push-pin up/down or alarm release.


Edit: Turns out you have to turn auto leveling off before selecting 3d touch.

Maccron
Posts: 19
Joined: Sun Jun 02, 2019 5:03 am

Re: Firmware with working 3D touch?

Post by Maccron » Sat Jan 25, 2020 1:30 pm

Yes, it works.

I received my A30M with this firmware.
I installed 3D Touch, and I activated it on the leveling menu without problems.
A30M with 3DTouch.

liberator
Posts: 2
Joined: Sat Dec 07, 2019 8:44 am

Re: Firmware with working 3D touch?

Post by liberator » Mon Jan 27, 2020 3:31 am

Yes, I too finally figured out from the poor wording in the manual that you have to turn off the auto-level switch icon to go to 3d touch from the CAS default.

Then once you select the 3d touch sensor, you switch the auto-level back on.

It tests fine on the up down and alarm. Also, when you hit the measure icon, it goes to the center position where you can set the offset, so the sensor is working.

How do you get it to "auto level" and go to all 9 other positions??? We need the auto level, since the plate is warped enough so that manual level does not allow a uniform thickness first layer to be put down.

PLEASE HELP ASAP. THANKS

Maccron
Posts: 19
Joined: Sun Jun 02, 2019 5:03 am

Re: Firmware with working 3D touch?

Post by Maccron » Wed Jan 29, 2020 3:59 am

To use auto bed leveling with 3D/BL Touch, you need to add G29 in your Starting Gcode

mine is :

;=======================
; Starting G-Code
;=======================
G21 ;metric values
G91 ;relative positioning
G1 E-10 F300 ;Retract the filament a bit before lifting the nozzle
G90 ;absolute positioning
M82 ;set extruder to absolute mode
M107 ;start with the fan off
G28 X0 Y0 ;move X/Y to min endstops
G29 ;autobedleveling
G1 Z15.0 F9000 ;move the platform down 15mm
G92 E0 ;zero the extruded length
G1 F200
;G92 E3
M117
;=================
; PRINTING
;=================
A30M with 3DTouch.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest