A20T - T-series - please improve MIXER RATIO

Post Reply
alfvv12
Posts: 26
Joined: Sun Jul 12, 2020 6:06 pm

A20T - T-series - please improve MIXER RATIO

Post by alfvv12 » Fri Jan 21, 2022 10:21 pm

hello.

ok, i know, there is a program named color-mixer. but the mixer function in the T-models are not user friendly and incomplete.

in M-series (2 colors) each mixer ratio E0 to E1 is selectable. 2:98, 15:85 etc.

in T-series (3 colors) it is NOT possible to set the ratio for EACH extruder, E0, E1, E2. if E0 is change, both of the other extruders E1 and E2 are changed automatically.

please improve this. it seems not really difficult.

1) focus is switchable between E0 and E1
2) if focus is selected on E0
a) the % from E0 is changable from 0 to 100 %.
b) if E0 is changed, the % of E2 should changed automatically. if % is 0, then E1 should be changed.
c) sum E0 E1 E2 is always 100.
3) 2) if focus is selected on E1
a) the % from E1 is changable from 0 to 100 %.
b) if E1 is changed, the % of E2 should changed automatically. if % is 0, then E0 should be changed.
c) sum E0 E1 E2 is always 100.

this programming is not complete, only to point out the procedure of mixer ratio setting.

hope you agree.

thanks.

Post Reply