Cannot push one color through the hot end

jackrats
Posts: 13
Joined: Tue Dec 31, 2019 1:39 am

Re: Cannot push one color through the hot end

Post by jackrats » Fri Jan 03, 2020 2:39 pm

Thanks William. That was my suspicion. I will contact support again. Thanks!

jackrats
Posts: 13
Joined: Tue Dec 31, 2019 1:39 am

Re: Cannot push one color through the hot end

Post by jackrats » Thu Jan 16, 2020 6:43 am

Just for closure, Tony at Geeetech was able to send me a new hot end. Swapped it in and I am now able to use all 3 extruders.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest