Magnetic Hotbed

[Stevo61]

Hi can anyone tell me if there is a magnetic hotbed available for the A20T as I have great difficulty removing models from the heated bed after completion, I have the reheat the heated bed and then it is a real struggle to remove the model it is so hard that I am afraid that I am going to damage the printer. I had a similar problem with my Creality CR-X and a magnetic bed cured the problem but I can't find one to fit the A20T.

[William]

Hi,You can try Mylar with magnetic plate.
Or increase the number of underlying layers

[Oli99959]

Hi can anyone tell me if there is a magnetic hotbed available for the A20T as I have great difficulty removing models from the heated bed after completion, I have the reheat the heated bed and then it is a real struggle to remove the model it is so hard that I am afraid that I am going to damage the printer. I had a similar problem with my Creality CR-X and a magnetic bed cured the problem but I can't find one to fit the A20T.

Hi,

I have the same issue. Removing the items is a nightmare.

Did you find a magnetic bed that fits?

Cheers
Oli

[pterry64]

I am having the same problem and am considering returning the printer as it is almost unusable

[andrevanderweide]

by one to big from creality and cut it a little works perfect

grt André

[Ade O]

how about getting 2 magnetic covers for the bed glue one down on the hot bed with the correct polarity so to attract the other then you can do the same without buying a new magnetic heated bed or am I being dense and not understanding the problem

[Oli99959]

how about getting 2 magnetic covers for the bed glue one down on the hot bed with the correct polarity so to attract the other then you can do the same without buying a new magnetic heated bed or am I being dense and not understanding the problem

Since my last post I bought a Ziflex magnetic bed. It costs 49€ (including postage to EU) and it's basically what you describe. It's two plates both made of a magnet that attract each other. One is glued on the printer bed, the other goes on the top.

The print sticks very well during printing and is extremely easy to remove. I clean it with washing up liquid and water. I have it only for 5 days but so far so good.

[Ade O]

oh nice ill have to get one I have to take a sharpened scraper and pap it with something to get them off mine sometimes and I don't think its good for it I don't know why I haven't done it already doh

[3DMike]

Hello,

go to Amazon and search the ean Code 0738678973325

BCZAMD 3D printing construction plate steel spring plate bed 260x260 mm (10,2x10,2 inch) steel plate with PEI + magnetic sticker B surface printing incubators for GEEETE A20, A20M, A20, Tronxy X5SA

this is the magnetic plate i use. very easy to attach, very good adhesion and easy removal of the printed parts.

Best Regards,
Michael

[Jarda3d]

Use Geeetech SuperPlate and you will get out all problems with sticking.