Level of the Heat Bed on A20T

Post Reply
cala
Posts: 8
Joined: Sun Dec 22, 2019 4:23 am
Location: Switzerland

Level of the Heat Bed on A20T

Post by cala » Sun Apr 12, 2020 7:52 am

Hi,

I have levelled my printer A20T following the documentation and video provide by Geeetech on the site.
I have printed the model successfully. But when I like to print some model higher, I have a problem on the first layer and the printing don't continue correctly at quality level spoking.

Then I have take a mode into tinternet to print a Levelling control. See the result into the picture attach.

Can you please help me to solve it?
When I check the levelling using the level check function from the printer, the 4 corner of the Bed are OK. But when I go to the middel of the printer, then paper is block and don't move. The Nozle is totally on the Bed.

The printer is new.

Best regards,

Calà Salvatore

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Level of the Heat Bed on A20T

Post by William » Mon Apr 13, 2020 9:45 am

Hi, You can check whether your hot bed itself is flat,
Then check the lower height setting, it is generally recommended to be 80% of the nozzle diameter.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

cala
Posts: 8
Joined: Sun Dec 22, 2019 4:23 am
Location: Switzerland

Re: Level of the Heat Bed on A20T

Post by cala » Tue Apr 14, 2020 4:29 am

Thanks for the reply.
I have install a btouch to prevent the problem.
Seams the hex file on your site don't work correcly.
Impossible to calibrate.

Post Reply