Help with purge line Gcode

Post Reply
masanseti
Posts: 1
Joined: Tue Jul 26, 2022 1:57 pm

Help with purge line Gcode

Post by masanseti » Tue Jul 26, 2022 2:55 pm

Hi,

Since i updated Cura to 4.8.0, it seems the purge line disapperead.

I tried some code but no one was good.

Can someone share a simple startup purge line Gcode to add to Cura for my A20M ? This would help some filament stick better on first layer. Now i have to manually remove the few millimeters of filament down the nozzle just before print starts.

Best regards.

Post Reply