Super Plate

Post Reply
Kintalind69
Posts: 4
Joined: Sat Jul 25, 2020 5:48 pm

Super Plate

Post by Kintalind69 » Sun May 23, 2021 2:36 pm

Hello,,,
I’m very new in 3D printers’s world!
I bought geeetech A20M and superplate, but when I try to set it up the extruder goes too deep. I look around and I found that the problem is set the Z axis through firmware update , but i’m not able to do that. Can anyone help me?
I use cura for Mac as slicer. The 3 Main Types of Mouse Grips

User avatar
Admin
Posts: 486
Joined: Wed Nov 30, 2011 9:49 am

Re: Super Plate

Post by Admin » Tue May 25, 2021 3:31 pm

Hello, the limit switch of the Z axis can be reinstalled. You can install it lower.

Post Reply