I have a problem

Post Reply
Dommovoy
Posts: 2
Joined: Thu Aug 01, 2019 6:29 am

I have a problem

Post by Dommovoy » Thu Aug 22, 2019 5:38 pm

http://prntscr.com/ow02hr
http://prntscr.com/ow02ns

1. I reset to factory settings
2. I have adjusted the bar clamp
3. I changed the firmware
4. I changed the feed rate of the bar and added / removed rollback
everything is completely cleaned.

I ask you in detail, with pictures, for points to help in solving this problem

Sorry for my english

User avatar
William
Site Admin
Posts: 4215
Joined: Tue Jun 07, 2016 9:38 am

Re: I have a problem

Post by William » Thu Aug 22, 2019 5:52 pm

Hi, It seems that the distance between your two gears is too close,
you can try to adjust the distance properly;
then adjust your printing speed (reference range 30-60mm / s).
I hope this can help you.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Dommovoy
Posts: 2
Joined: Thu Aug 01, 2019 6:29 am

Re: I have a problem

Post by Dommovoy » Thu Aug 22, 2019 11:23 pm

I adjusted these settings, both physically and programmatically, did not help

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest