hello I come to you because yesterday my printer arrived a20m bought by gearbest. make the assembly and tighten all the screws and pass from 220v to 115v because in my country 115v is used. when I turned on the printer reach to calibrate the bed when I put filament and told him to heat bed and extruder to make the first impression, the screen went off and does not move anything goes what I show below in the photos and videos
video fail . https://www.youtube.com/watch?v=v0wmoR_ ... e=youtu.be
fail a20m
Re: fail a20m
Hello.
Your video shows an inactive 5V LED.
In the first photo you marked two fuses.
Can you check if they are working?
Alternatively, remove them from the sockets and insert them again.
Your video shows an inactive 5V LED.
In the first photo you marked two fuses.
Can you check if they are working?
Alternatively, remove them from the sockets and insert them again.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Re: fail a20m
My friend thanks for your answer but problem is solved change the fuses it's oks