Need help with my geeetech a20

Post Reply
singtneyu
Posts: 1
Joined: Fri Apr 01, 2022 2:40 pm

Need help with my geeetech a20

Post by singtneyu » Fri Apr 01, 2022 3:21 pm

Hey guys, so I'm new to 3D printing. I've got my hands on a geeetech a20 and after assembling the printer with the help of an awful manual, it was almost ready. To level the printer, the manual told me to fasten all four feather screws that hold up the hotbed. After I did that, I turned the printer on and pressed "auto home". The printer automatically moved the nozzle to the bottom left nearside corner. But here's my problem: Since the Z axes is already down so much that the Z POS Sensor doesn't allow any further movement down, the nozzle is about 5-10mm above the hotbed. Does anyone know a fix for that? I think moving it up with the feather screws will mess up the evenness of the hotbed.

Thank's already!

Post Reply